Product Description:

The MDD093C-N-040-N2L-130GA0 synchronous servo motor is produced by Bosch Rexroth Indramat as part of the MDD Synchronous Motors series. It is intended for use with digital drive controllers and provides closed-loop motion for factory automation. In positioning tables, handling modules, and similar servo axes, the motor converts controlled electrical input into regulated torque and speed. This operating principle allows precise starts, stops, and speed changes during repetitive machine cycles, and it suits applications where repeatable rotary motion must stay coordinated with controller commands.

The rotor uses standard balancing, which helps keep vibration low at rated speed. A centering flange with a diameter of 130 mm aligns the housing with machine interfaces, and the 093 frame with C length provides the motor's active magnetic package. Power and feedback conductors exit on Side A through a keyed connector, which keeps both cable paths oriented in the same direction and simplifies routing in compact machine spaces. Under nominal load, the shaft reaches 4000 rpm, and the drive matches electrical commutation to rotor position during operation. Heat is removed by natural convection, so no external coolant lines are required.

Position data is returned through digital servo feedback (DSF), allowing the connected drive to close high-resolution speed and position loops without a separate external encoder. The motor is supplied without a blocking brake, so any holding force during a power-off condition must come from the drive or an external clamp. A fitted shaft seal helps limit the entry of coolant and fine dust at the housing interface, while the plain shaft provides a straightforward coupling surface for pulleys or gearboxes. The motor has a single shaft end with no secondary shaft on side B, which simplifies the output arrangement and leaves only one mechanical drive point to align.