Product Description:

The MDD093C-N-040-N2L-110PR1 is a synchronous servo motor manufactured by Bosch Rexroth Indramat within the MDD Synchronous Motors series. Designed for digital drive controllers, it delivers closed-loop torque and speed to automated axes used in handling stations, packaging modules, and transfer lines. The integrated blocking brake helps secure vertical or suspended loads during shutdown, while the electronic feedback channel sends rotor position data to the drive for accurate commutation under changing demand. This operating profile suits machinery that requires repeatable motion, controlled stopping, and stable speed regulation during frequent cycle changes.

The motor is in size 093, and its flange has a centering diameter of 110 mm for direct seating on machine frames. Power and signal leads exit on the right side through a sealed connector set, which can simplify cable routing in enclosed equipment. A standard housing and standard balancing class support smooth rotation without special vibration treatment. The motor uses length code C, which gives it a longer active stack than codes A or B and increases continuous torque capacity. Rotary motion is transferred through a keyway shaft, and an oil-lip seal helps limit lubricant migration at the output journal.

Control-loop data are delivered by digital servo feedback electronics that report position and speed to the drive in real time. Under rated excitation, the rotor can achieve 4000 rpm, which is suitable for fast point-to-point moves in servo gantries and transfer systems. The holding brake provides 11 Nm of static torque, allowing loads to remain stationary without external clamps when power is removed. The motor also has a shaft seal, which helps support IP65 protection at the coupling area against dust and water spray. This feedback arrangement allows the drive to maintain smooth commutation during acceleration, deceleration, and low-speed operation.