Product Description:

The MDD093C-N-040-N2L-110PL1 is a synchronous servo motor manufactured by Bosch Rexroth Indramat within the MDD Synchronous Motors series. Intended for operation with digital drive controllers, it converts electrical commands into regulated rotary motion for positioning and velocity control in machine tools, packaging stations, and material-handling equipment. Its synchronous design supports accurate response in applications that need repeatable motion, quick correction of load disturbances, and stable speed regulation during frequent starts, stops, and direction changes.

Its nominal speed of 4000 rpm represents the maximum continuous rotor velocity achievable at rated conditions. A blocking brake fitted inside the frame supplies 11 Nm of static holding torque so vertically mounted loads remain secure when power is removed. Position data return through digital servo feedback (DSF), giving the drive high-resolution angle information for tight loop control. All power and signal leads exit on the left side, which can simplify routing when adjacent components share the same cable direction. The motor uses a connector interface for its electrical connections, and a centering diameter of 110 mm aligns the flange to the machine frame to reduce runout during installation.

Length code C identifies an extended active stack that raises continuous power without changing the 93 mm frame width. The output shaft uses a keyway profile, allowing standard keyed hubs to transmit torque without slip. The motor is equipped with a shaft seal, which helps block lubricant migration and keeps airborne coolant or dust away from the bearings. Standard dynamic balancing limits vibration, and the standard housing style keeps external dimensions consistent with other motors in the series. The motor has no rear shaft end, which leaves space for the encoder and brake hardware without increasing the overall length.