Product Description:

The MDD093C-N-040-N2L-110PB0 is an AC servo actuator built by Bosch Rexroth Indramat and assigned to the MDD Synchronous Motors series. It is intended for automated machinery that depends on a compatible drive controller and closed-loop feedback for accurate speed and position control. By converting electrical input into controlled rotary motion, the motor can drive tooling tables, packaging axes, or pick-and-place arms with repeatable movement. Its synchronous design supports responsive operation during both rapid indexing and steady-running motion tasks.

This model reaches a nominal speed of 4000 rpm, allowing fast positioning cycles when the connected drive supplies the required command signals. A 110 mm centering diameter supports accurate alignment with standard flange bores during mounting. Power and feedback conductors exit through a sealed connector on side B, which helps keep cable routing organized at the rear of the motor. Torque is transmitted through a shaft with a keyway for keyed couplings, and a shaft seal helps limit contaminant entry while retaining internal lubricant. Frame size 093 with length code C gives the motor the corresponding active magnetic stack within this product line. Integrated digital servo feedback provides the controller with position data needed for regulated motion.

A standard housing encloses the stator and matches the usual mounting pattern used across the series. The motor is supplied without a blocking brake, so position holding after power removal must be provided by drive torque or an external holding device. The unit is a motor for digital drive controllers, indicating that its feedback arrangement and electrical characteristics are intended for compatible digital control platforms. The rotor is balanced to a standard grade, and the shaft uses a single standard shaft end with no secondary output on side B.