Product Description:

The MDD093C-N-030-N2M-130PR2 is a synchronous servo motor produced by Bosch Rexroth Indramat in the MDD Synchronous Motors series. Designed for digital drive controllers, it converts commanded current into controlled rotary motion for positioning and speed control on automated axes such as gantry drives, tool changers, and packaging actuators. Its mechanical interface, multi-turn feedback, and integrated brake support secure load holding, accurate motion profiles, and continuous status reporting to the connected drive electronics. This layout suits applications that must maintain stable axis behavior during repeated starts, stops, and position changes.

The motor has a nominal speed of 3000 rpm, which is the rated shaft speed during normal operation. A centering diameter of 130 mm aligns the housing on the machine plate and helps maintain concentricity with connected components. The blocking brake provides 22 Nm of holding torque so vertical or suspended loads can remain stationary during power-off conditions. Power and feedback conductors exit on the right side, which supports lateral cable routing in compact cabinets. Torque is transmitted through a keyway shaft for secure coupling to gears or pulleys, and closed-loop control uses digital servo feedback (DSF) for accurate position, speed, and torque regulation.

The electrical interface uses a sealed connector, so the cable connection remains enclosed during operation. Rotor position is measured by an integrated multi-turn absolute encoder, which retains revolution data through power cycles and removes the need for homing after startup. The motor has length code C, which uses a longer stator stack than shorter motors in the 093 frame to increase continuous torque. Standard dynamic balancing helps limit vibration during operation. The housing has a standard protective finish, a shaft seal helps block contaminants, and the motor uses a single-ended shaft without a side B extension.