Product Description:

The MDD093C-N-030-N2M-130PL2 is a synchronous servo motor manufactured by Bosch Rexroth Indramat within the MDD Synchronous Motors series. It is intended for direct connection to digital drive controllers in applications that require accurate torque and speed regulation. As a synchronous servo motor, it converts regulated electrical input into controlled rotary motion for closed-loop axes. Typical uses include packaging equipment, material handling systems, and other automated motion platforms where repeatable motion is required.

This model uses standard dynamic balancing to reduce vibration during operation. It has a centering flange diameter of 130 mm for accurate housing alignment, and the power and feedback lines exit on the left side through a sealed connector. The rotor reaches a nominal speed of 3000 rpm, which suits high-speed positioning tasks and other applications that need a wide operating range. A blocking brake rated at 22 Nm holds axis position when the drive is disabled, and a shaft seal helps prevent lubricant from entering the motor interior. Standard housing geometry also supports installation in enclosed machine assemblies where alignment and cable routing must remain consistent.

Feedback is provided through Digital servo feedback, and absolute position data is supplied by an Integrated multi-turn absolute encoder, so the controller can track rotor position after a power interruption without a new homing cycle. Because the encoder is multi-turn, it can report position across multiple revolutions rather than only within a single turn. The output shaft uses a keyway to provide positive coupling for pulleys, hubs, or similar drive components. The motor has length code C, which gives it a longer active stack than shorter frame lengths and supports higher continuous torque with a compatible inverter. The motor also has a single shaft end, so a second shaft extension is not present.