Product Description:

The MDD093C-N-030-N2M-130GA0 is a synchronous servo motor manufactured by Bosch Rexroth Indramat for the MDD Synchronous Motors series. It functions as a rotary actuator for digital drive controllers, converting drive commands into precise shaft motion required in automated assembly lines, packaging machines, and other positioning tasks where consistent velocity and repeatability are essential. This arrangement supports accurate starts, stops, and repeated positioning during continuous production cycles. The omission of a side-B shaft extension shortens overall length, and the standard housing keeps installation straightforward in common machine layouts.

At a nominal speed of 3000 rpm, the rotor stays synchronized with the drive’s frequency so high-cycle equipment can index without drift. The centering pilot is 130 mm in diameter, giving the motor a broad register surface that helps hold radial runout within tolerance. Power and feedback leads exit on Side A, which helps keep cable routing on one machine side. A sealed connector interface permits rapid exchange while shielding the contacts from oil and dust. Position information is supplied by an integrated multiturn absolute encoder, enabling the controller to recover shaft angle immediately after power-up without a homing sequence. The motor occupies length code C within the 093 frame.

Rotor angle is streamed to the drive through digital servo feedback, allowing tight velocity and position loops. Because the unit is delivered without a blocking brake, any required hold-in-place function must be provided externally. The cylindrical plain shaft is protected by a shaft seal that limits coolant or dust ingress while keeping friction low. Vibration is moderated by standard balancing, which supports smooth running close to nominal speed. The shaft seal also helps protect the bearing area during routine machine operation.