MDD093C-N-030-N2M-110PL1 Bosch Rexroth Indramat
Wake Industrial LLC is not an authorized distributor of this product.
- Straightforward Pricing: No Rush Fees, No Credit Card Fees
Current response time:
6 Minutes
35 Seconds
The Bosch Rexroth Indramat MDD093C-N-030-N2M-110PL1 is part of the MDD Synchronous Motors series and is designed for use with digital drive controllers. This motor features an integrated multiturn absolute encoder, digital servo feedback, and a holding brake with an 11 Nm torque. It has a centering diameter of 110 mm, a nominal speed of 3000 min⁻¹, and a shaft with a keyway and shaft seal.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The MDD093C-N-030-N2M-110PL1 synchronous servo motor is produced by Bosch Rexroth Indramat within the MDD Synchronous Motors series. Designed for digital drive controllers, it converts electrical energy into controlled mechanical rotation for positioning and speed-regulated tasks in automated machinery. Standard balancing and housing permit general-purpose mounting, and the keyway shaft end transmits torque directly to couplings or pulleys. An internal blocking brake secures the axis when power is removed, which is useful on vertical or suspended loads. This arrangement suits machine axes that need repeatable starts, stops, and speed changes during normal production.
During continuous operation, the motor reaches a nominal speed of 3000 rpm, enabling close tracking between commanded speed and actual shaft rotation. The mechanical interface centers on a 110 mm locating pilot, which helps maintain concentric alignment in gearboxes or mounting plates. Motion is held by an electromagnetic brake with 11 Nm of static torque, which keeps moderate loads stationary without external clamps. Power and feedback conductors exit on the left side, simplifying cable routing when multiple axes are installed next to each other. Positional information is supplied by an integrated multi-turn absolute encoder, so the controller receives rotor angle and revolution count immediately after power-up without a homing cycle. The brake is intended to hold position when the axis is stopped, while normal deceleration is handled by the drive.
The motor uses size 093 with length code C, giving a housing format that balances torque capacity with manageable inertia. A shaft seal helps limit the entry of dust and moisture at the output end, which supports reliable bearing operation in demanding environments. Command loops close through digital servo feedback (DSF), allowing the drive to adjust motor current in real time according to the position signal. This supports smooth correction during acceleration, deceleration, and low-speed positioning. The overall layout is suitable for automated axes that require controlled motion and stable holding when power is removed.
Frequently Asked Questions about MDD093C-N-030-N2M-110PL1:
Q: What type of encoder is used in the MDD093C-N-030-N2M-110PL1 motor?
A: This motor features an integrated multiturn absolute encoder.
Q: Does the MDD093C-N-030-N2M-110PL1 come with a holding brake and what is its torque?
A: A blocking brake is included, providing a holding brake torque of 11 Nm.
Q: What is the nominal speed of the MDD093C-N-030-N2M-110PL1 synchronous motor?
A: The MDD093C-N-030-N2M-110PL1 motor has a nominal speed of 3000 min⁻¹.
Q: What is the direction and type of the electrical connection on the MDD093C-N-030-N2M-110PL1?
A: A connector is used for electrical connections and is oriented to the left.
Q: What shaft features does the MDD093C-N-030-N2M-110PL1 motor have?
A: The shaft on this motor is a keyway type and includes a shaft seal for protection.
