Product Description:

The MDD093C-N-030-N2M-110GL2 is a synchronous AC servo motor manufactured by Bosch Rexroth Indramat for the MDD Synchronous Motors series. Designed for digital drive controllers, it converts regulated three-phase current into precise rotary motion for positioning and velocity axes in automated packaging lines, handling systems, and machine tools. The motor interfaces directly with an electronic drive that supplies current, monitors feedback, and applies control algorithms to maintain tightly controlled motion profiles in industrial automation. This arrangement supports accurate speed regulation and repeatable axis movement during continuous production cycles.

Rated for a nominal speed of 3000 rpm, the rotor can maintain this reference velocity when the controller delivers rated current and frequency. A blocking brake built into the end bell supplies 22 Nm of static holding torque so vertical or suspended loads remain stationary after power-off. Position and velocity data reach the drive through digital servo feedback (DSF), while an integrated multi-turn absolute encoder tracks rotor angle over multiple revolutions for homing-free startups. Power and signal connectors exit on the motor’s left side, helping panel builders arrange cable runs without sharp bends. Separating power conductors from signal wiring inside the machine also helps reduce electrical noise in the feedback path.

The mechanical interface supports precise alignment through a centering pilot of 110 mm, and the ground output shaft is a plain shaft. To protect the bearing cavity during washdown cleaning, the front end uses a shaft seal. Frame size 093 and motor length code C provide moderate mass and thermal capacity suited to mid-range drive packages. Standard balancing and a standard housing finish support direct coupling to gearboxes or belt pulleys, while a keyed connector helps simplify installation and cable attachment.