Product Description:

The MDD093C-N-030-N2L-130PA2 is a synchronous servo motor built by Bosch Rexroth Indramat for the MDD Synchronous Motors series. Delivered as a motor for digital drive controllers, it converts drive current into accurately regulated torque so that automated axes can follow programmed motion profiles in assembly lines, tool systems, or packaging stations. This supports indexing, feed axes, and coordinated motion tasks that rely on stable torque delivery and predictable response under changing load conditions. The model’s standard housing and internal balancing minimize vibration, while its blocking brake secures the load whenever the drive is disabled.

The stator flange carries a centering diameter of 130 mm, giving a precise pilot surface for coaxial alignment with gearboxes or mounts. Under rated excitation, the rotor reaches a nominal speed of 3000 rpm, which suits constant-velocity processes in compatible drive systems. Mechanical size code 093 sets the frame envelope, and length code C extends the active stack so that higher continuous torque is available without changing the mounting pattern. Power and feedback cables exit on Side A, which helps simplify routing when multiple motors are installed in parallel rows.

The integrated blocking brake develops 22 Nm of holding torque to keep vertical or overhung loads stationary during power loss. Position information is returned through digital servo feedback, enabling the controller to close high-resolution loops without external encoders. The output shaft is machined with a keyway to transmit torque through keyed couplings, and a radial shaft seal helps limit lubricant migration. The shaft seal also helps keep contaminants away from internal bearing areas during normal industrial operation. A plug-in connector carries phase conductors and brake power. The motor uses standard balancing, a single-ended shaft with no side B extension, and a general-purpose housing finish.