Product Description:

The MDD093C-N-030-N2L-130PA1 synchronous servo motor is built by Bosch Rexroth Indramat as part of the MDD Synchronous Motors series. Classified as a motor for digital drive controllers, it converts electrical energy into commanded torque so packaging lines, pick-and-place modules, and assembly cells can move with synchronized accuracy. The unit combines permanent-magnet excitation with integrated rotor position sensing, allowing its paired drive to regulate motion precisely under changing loads in industrial automation. This arrangement supports accurate acceleration, deceleration, and positioning during repetitive machine cycles.

The motor seats against the machine frame through a centering pilot of 130 mm, which helps keep radial runout low when the flange is bolted in place. During operation, the rotor can sustain a nominal speed of 3000 rpm, supplying steady velocity for indexing tables and similar axes. Frame designation 093 identifies the motor size used for this housing. Rotor position is returned through digital servo feedback (DSF), giving the controller high-resolution angle data for tight velocity and position loops. For holding duty, an internal blocking brake provides 11 Nm of static torque to secure the shaft when the drive is disabled.

Cabling is terminated through a molded connector, and all power and feedback lines leave on Side A, which can simplify routing in compact control cabinets. The magnetic stack depth corresponds to length code C, giving higher continuous torque than shorter versions without increasing motor diameter. Output torque is transmitted through a keyway shaft, and the shaft seal helps limit dust and coolant entry at the bearing lip. The motor is supplied with the brake already installed, uses a standard housing, and follows the standard balancing grade for smooth rotation. It also uses a single-ended shaft layout, leaving side B free for the mounting arrangement.