Product Description:

The MDD093C-N-030-N2L-110PA0 is a synchronous servo motor in the MDD Synchronous Motors series manufactured by Bosch Rexroth Indramat. It is intended for use with digital drive controllers that require accurate closed-loop motion in industrial automation cells. In packaging lines, pick-and-place robots, and material-handling axes, the motor converts three-phase electrical energy into controlled rotary motion for positioning and speed-regulated tasks. Its compact format allows it to fit standard machine layouts where reliable servo performance and consistent response are required during repeated production cycles.

For continuous duty, the rotor can run at a nominal speed of 3000 rpm, allowing coordination with common inverter operating ranges while maintaining stable torque. Accurate mechanical alignment is achieved through a centering diameter of 110 mm, which helps seat the motor in the mounting pilot bore and reduces shaft runout during operation. All power and feedback conductors exit on Side A, which helps keep cable routing organized where space around the motor is limited. The electrical interface uses a single industrial connector that locks to the housing and carries both phase and sensor lines. The motor length code C indicates the three-stack stator configuration used for this frame size.

Closed-loop control is supported by Digital servo feedback (DSF), which provides high-resolution position data directly to the drive. Contaminant ingress is limited by a fitted shaft seal, helping protect the front bearing and retain internal lubricant. Mechanical output is transmitted through a standard keyway shaft, making the motor suitable for couplings and driven elements that use keyed torque transfer. The motor is supplied without a blocking brake, so load holding at standstill must be handled by the application or by an external device. This arrangement reduces rotating mass and suits systems that already use separate holding mechanisms.