Product Description:

The MDD093C-N-030-N2L-110GR2 is a synchronous servo unit produced by Bosch Rexroth Indramat for the MDD Synchronous Motors series. Classified as a motor for digital drive controllers, it supplies regulated torque and velocity to automated axes, allowing coordinated motion within machine tools, packaging lines, and material-handling gantries. It translates drive commands into repeatable rotary movement while sharing position data with the system controller. This operating role supports accurate speed regulation and consistent positioning during cycles that include frequent starts, stops, and reversals.

The motor is built on size code 093, giving a frame diameter that fits mid-range power classes. It has a nominal speed of 3000 rpm, which is its rated operating velocity under synchronous excitation and suits common inverter output ranges. A rated holding brake torque of 22 Nm secures loads during power-off or emergency stops, and the brake is integrated into the motor housing. The centering diameter of 110 mm helps align the motor concentrically on machine interfaces. Position accuracy is maintained through digital servo feedback, which sends position data to the drive for stable closed-loop control during rapid reversals and changing loads.

Power and feedback conductors exit on the right side through a connector interface, which supports orderly cable routing where clearance is limited above or beside the motor. The rotor length follows code C, adding active iron for higher continuous torque without changing the mounting footprint. The output uses a plain shaft with a shaft seal, and the shaft end is provided only on side A so couplings mount directly on the smooth journal. Standard dynamic balancing helps keep vibration controlled at operating speed, which supports bearing life and steady running in repeated motion service.