Product Description:

The MDD093C-N-020-N2M-130GB0 belongs to the MDD Synchronous Motors series produced by Bosch Rexroth Indramat. It is a brushless AC motor intended for use with compatible digital drive controllers and supplies closed-loop motion in automated machinery. By combining encoder feedback and direct connector interfaces, the unit delivers position-accurate rotation for packaging stations, gantry axes, and similar industrial tasks where consistent velocity and torque are needed. Its brushless design also supports low-maintenance operation during repeated start-stop cycles.

The mechanical interface uses a centering diameter of 130 mm, giving the mounting flange a reference surface that aligns the stator with adjoining machine frames. Under rated conditions, the rotor runs at a nominal speed of 2000 rpm, which suits many transfer and positioning axes. Power and feedback conductors exit on Side B, which can simplify cable routing when the motor is mounted on a right-hand machine wall. A circular connector couples the cable set without additional glands. The length code C indicates the third-longest stack in the 093 frame and supports higher continuous torque than shorter versions in the same size.

The drive train ends in a plain shaft, which suits clamp couplings or shrink disks, and it is equipped with a shaft seal to limit oil or coolant ingress at the bearing seat. Angular and revolution data are returned through Digital servo feedback (DSF), allowing the drive to track rotor position accurately during motion. For applications that hold position mechanically or through drive torque, the motor is supplied without a blocking brake. Standard dynamic balancing reduces residual vibration, and the housing uses standard cooling ribs to support heat dissipation during continuous operation. The single-sided shaft end also leaves the coupling area clear for alignment.