Product Description:

The MDD093C-N-020-N2M-110PR0 is a synchronous servo motor produced by Bosch Rexroth Indramat for the MDD Synchronous Motors series. It is intended for use with digital drive controllers and closed-loop motion axes in automated machinery. The motor uses size 093 with the longer C length code, which gives it a deeper stator stack for higher torque density than shorter versions in the same frame. Standard balancing keeps vibration within normal limits, and the housing uses the standard configuration for general industrial environments.

The centering pilot on the flange is machined to a diameter of 110 mm, allowing accurate concentric seating against gearbox or machine faces and helping reduce radial runout. During operation, the rotor can reach a nominal speed of 2000 rpm, which suits positioning tasks that require moderate velocity with high torque. Motor wiring is routed through a rugged connector interface, so cables can be connected without opening the housing. Position and velocity feedback are handled through Digital servo feedback (DSF), which sends high-resolution signals to the drive for precise control. The motor is supplied without a blocking brake, so static holding torque must be provided externally when power is removed.

Signal handling is further supported by an integrated multiturn absolute encoder, which reports both position and revolution count without requiring homing after startup. Power and feedback leads exit toward the right side of the motor, which can simplify cable routing in layouts that match that orientation. Torque is transmitted through a shaft with a keyway, and the output end is supplied with a shaft seal to help limit lubricant escape and dust entry. The shaft end follows the standard single-ended configuration, so there is no secondary extension on side B.