Product Description:

Bosch Rexroth Indramat manufactures the MDD093C-N-020-N2L-130GR0. This unit is a synchronous motor in the MDD Synchronous Motors series and serves as an electromechanical actuator for digital drive controllers used in packaging lines, material-handling axes, and general motion tasks. It converts commanded current into rotational movement so the controller can position loads with precise velocity and torque control in automated production. The motor is intended for closed-loop operation where stable speed response and repeatable positioning are required during continuous machine cycles.

The motor’s nominal speed is 2000 rpm, allowing drives to operate conveyors or indexers at moderate speed without pushing the winding beyond its intended operating range. A centering diameter of 130 mm provides a stable register in machined mounting faces, helping maintain alignment during installation. Power and feedback conductors exit on the right side through a single connector, which helps keep cable routing orderly when multiple axes are stacked. Position and velocity data are returned through digital servo feedback (DSF), allowing the drive to close a fast servo loop and maintain accurate motion under changing load. Standard dynamic balancing helps reduce vibration, and the standard housing protects the stator laminations from oil mist that may be present in industrial environments.

The motor is supplied without a blocking brake, so vertical loads must be held by external clamping or by drive torque when power is removed. It has a C length code, which gives the motor a longer active stack for higher continuous torque while keeping the same outside diameter. The output uses a plain shaft fitted with a shaft seal, which supports direct coupling to pulleys, gearboxes, or flexible couplings while helping limit lubricant migration toward the bearings. This shaft arrangement keeps the mechanical interface straightforward for machines that use standard transmission components.