Product Description:

The MDD093C-N-020-N2L-110PL1 is a synchronous servo motor manufactured by Bosch Rexroth Indramat for the MDD Synchronous Motors series. It is intended for use with digital drive controllers, where it converts commanded current into repeatable rotary motion for packaging equipment, transfer lines, and general factory automation. The motor supports accurate acceleration, deceleration, and position holding in compact multi-axis machines. Its integrated feedback arrangement helps the controller maintain stable velocity and positioning during changing load conditions.

The mechanical interface uses a centering diameter of 110 mm, which helps seat the motor concentrically to the driven load and reduce runout. Power and feedback leads exit on the left side through a sealed connector, which helps simplify cable routing where installation space is limited. During operation, the rotor reaches a nominal speed of 2000 rpm, giving the axis a practical balance between continuous-duty performance and thermal loading. A blocking brake rated at 11 Nm is mounted in the rear housing, and it holds the shaft when power is removed or when a vertical axis must remain in place without drive current.

Signal accuracy is provided by the integrated digital servo feedback (DSF) system, which returns high-resolution position data to the controller for closed-loop speed and position control. The output shaft uses a keyway and a shaft seal, allowing secure torque transmission while helping keep contaminants away from internal components. The C length code indicates an extended stator package that supports higher continuous torque within this frame size. The motor also uses a standard housing configuration, which suits typical industrial mounting arrangements and keeps the external form familiar within the product line.