Product Description:

The MDD093C-N-020-N2L-110PB2 is a synchronous motor built for direct pairing with digital drive controllers in automated machinery. In closed-loop axes, it supplies continuous rotary power for positioning, feeding, and handling motions that require stable torque and repeatable response. An integrated blocking brake keeps vertical or suspended loads from drifting at rest, so the axis can remain secure when operating power is removed. Its synchronous design supports accurate speed regulation and controlled positioning during repeated machine cycles.

The motor reaches a nominal speed of 2000 rpm, allowing moderate-speed positioning tasks without exceeding common servo operating ranges. A blocking brake rated at 22 Nm holds the shaft in place when power is removed. The centering pilot of 110 mm aligns the motor on the mounting flange, and the power and feedback conductors exit from Side B to support rear cable routing. This cable orientation can simplify installation where space is limited near the drive end. Position and velocity loops close through digital servo feedback (DSF), which sends rotor data to the drive for regulated motion and fast control correction.

Cabling is attached through a connector interface that provides a secure electrical connection and supports sealed cable entry. The drive end uses a keyway shaft so torque can be transferred through keyed couplings without slip, while the opposite end remains plain in the standard single-ended design. Frame designation 093 corresponds to the motor size, and length code C indicates an extended active stack for higher continuous torque than shorter lengths. A shaft seal helps reduce the entry of moisture or contaminants into the bearing area. The standard balancing grade limits residual vibration during sustained operation and supports smooth running in normal industrial duty.