Product Description:

The MDD093C-N-020-N2L-110GB1 is a synchronous servo motor manufactured by Bosch Rexroth Indramat for the MDD Synchronous Motors series. It is intended for use with digital drive controllers, where it supplies closed-loop torque and position control for automated machinery such as pick-and-place gantries, packaging axes, and similar motion systems. By working with the connected drive electronics, the motor converts commanded current into rotary motion with the consistency needed for positioning tasks, repeatable production cycles, and controlled speed changes under varying load conditions.

The unit reaches a nominal speed of 2000 rpm, giving the drive a fixed operating reference for gear ratio selection and cycle timing. Motion can be held during power loss because the blocking brake provides 11 Nm of static torque, which is useful on axes that must remain in place at standstill. Rotor position is returned through Digital servo feedback (DSF), enabling real-time vector control without an incremental encoder and allowing continuous monitoring of rotor angle during acceleration and deceleration. Power and feedback conductors exit on Side B through a single Connector, which keeps cable connection simple because no separate terminal box is used.

A centering register of 110 mm aligns the flange to machine plates or gearboxes for accurate mounting. The motor has size 093, and the C length indicates a deeper stator stack that supports higher continuous torque within the same flange pattern. A plain shaft transmits torque directly to a coupling, and a shaft seal is installed to help limit grease migration and dust entry. The housing uses a standard design with ambient-air cooling over the ribbed exterior, and the shaft end is provided only on the drive side so the rear profile remains compact for tight installation spaces.