Product Description:

The MDD093C-L-030-N2M-130GB1 is a synchronous servo motor produced by Bosch Rexroth Indramat and assigned to the MDD Synchronous Motors series. As a motor for digital drive controllers, it interfaces directly with compatible modular inverters to translate commanded current into regulated torque and speed. This allows repetitive positioning, contouring, and velocity-controlled duties on packaging lines, pick-and-place modules, and similar automated equipment. Its synchronous design also supports repeatable acceleration and stable motion response during frequent start-stop cycles.

A nominal speed of 3000 rpm sets the synchronous operating point for typical high-response motion tasks. The centering pilot measures 130 mm, providing concentric alignment against the mating flange and helping the motor seat accurately on the machine interface. Power and feedback conductors exit on side B through a connector, which keeps the cable interface at the rear of the housing. Rotor position is measured by an integrated multiturn absolute encoder, allowing the drive to retain absolute position information after power is removed. Size code 093 and length code C establish the housing envelope, and the lack of a shaft end on side B leaves the rear side clear for the connection set.

A blocking brake with a holding capacity of 11 Nm keeps the shaft stationary when drive power is removed. The stator jacket is prepared for surface cooling, so external thermal transfer can remove heat from the housing during continuous operation and low-speed duty. The motor uses digital servo feedback (DSF) for closed-loop data transmission, and the output uses a plain shaft with an integral shaft seal to protect internal bearings against dust and coolant. A sealed shaft arrangement is useful where splash or airborne contaminants may reach the drive end of the motor.