Product Description:

The MDD093C-L-030-N2M-130GA0 is a servo motor produced by Bosch Rexroth Indramat and supplied within the MDD Synchronous Motors series. Classified as a motor for digital drive controllers, it is used in automated production lines, material-handling axes, and packaging machinery to deliver precise rotary motion. By combining electronic commutation with high-resolution feedback, the unit converts electrical energy from a matched drive into controlled mechanical torque and speed for closed-loop automation tasks. Its design suits applications that require repeatable positioning, stable speed regulation, and accurate response to changing load conditions.

Motor length code C gives the unit an extended active stack for higher torque relative to the 093 frame. The rotor is dynamically balanced to the standard grade to minimize vibration at its nominal speed of 3000 rpm. Accurate shaft alignment is assisted by a centering recess measuring 130 mm in diameter, while power and feedback cabling exit on Side A through a plug-in connector that helps simplify routing in crowded cabinets. A shaft seal helps prevent dust and coolant ingress, yet the model is supplied without a blocking brake, so external holding devices are required whenever the axis must remain fixed after power is removed.

Heat produced in the stator is removed by a housing designed for surface cooling, allowing forced air or conductive mounting plates to carry away losses without internal fans. Rotary position is detected by an integrated multi-turn absolute encoder, and position data is transmitted through digital servo feedback (DSF), giving the controller absolute coordinates immediately after startup. A plain shaft configuration eliminates keyways, reducing stress concentrations and allowing clamp couplings for low-backlash torque transfer. This arrangement is well suited to continuous-duty motion systems where accurate feedback, stable thermal behavior, and dependable shaft coupling are required during repeated operating cycles.