Product Description:

The MDD093C-L-030-N2M-110GB2 is a synchronous servo motor produced by Bosch Rexroth Indramat within the MDD Synchronous Motors series. It is intended for use with digital drive controllers that regulate torque, speed, and position in closed-loop motion systems. The motor converts commanded current into rotary motion for packaging lines, woodworking cells, material-handling systems, and other automated machinery where cycle consistency is important. This operating role suits axes that must start, stop, and reverse without losing positional accuracy.

This model reaches a nominal speed of 3000 rpm, allowing drive controllers to support moderate throughput without overspeeding connected mechanics. Its centering diameter of 110 mm provides a repeatable reference surface so the stator can be aligned concentrically in gearboxes or machine frames. All power and feedback leads exit on Side B, which helps keep the opposite face free for mounting or adjacent hardware. Position data reaches the controller over digital servo feedback (DSF), improving loop resolution during rapid reversals. When power is removed, a blocking brake delivers 22 Nm of static torque so vertical or indexing axes do not drift. This combination supports accurate shaft control while helping the machine hold position during an idle state.

For thermal management, the housing uses surface cooling, allowing external air or conductive plates to draw heat away from the stator laminations. A plain shaft with a factory-installed shaft seal helps prevent lubricant migration while maintaining protection at the output end. The integrated multiturn absolute encoder reports both position and revolution count, so startup can begin without a homing move. Size code 093 places the rotor in the medium-frame category. Length code C uses a longer axial stack to increase continuous torque compared with shorter versions in the same motor family. Standard dynamic balancing limits vibration during high-speed cycles, and the shielded connector interface helps maintain stable electrical connections.