Product Description:

The MDD093C-L-030-N2M-110GB1 is a synchronous servo motor manufactured by Bosch Rexroth Indramat for the MDD Synchronous Motors series. Intended for pairing with digital drive controllers, it converts commanded current into tightly regulated torque so that automated tooling, indexers, and process lines reach target positions and speeds with repeatable accuracy. Mechanical balance is classified as standard, which helps limit residual vibration at couplings and gears during normal operation.

This model reaches a nominal speed of 3000 rpm, allowing high-cycle positioning without overspeeding the mechanical elements it drives. Its centering diameter of 110 mm aligns the stator housing precisely inside machine frames, reducing radial runout at the mounting interface. A blocking brake integrated in the rear section delivers 11 Nm of holding torque to secure loads whenever the main drive is de-energized. The housing is built for surface cooling, so heat is transferred directly to the mounting plate instead of being removed by a separate fan. Position and velocity data are returned to the controller through digital servo feedback (DSF), enabling closed-loop correction at every control cycle.

Power and feedback conductors exit on Side B, a configuration that simplifies cable routing where the opposite face is obstructed. The electrical interface uses a compact connector, which keeps the connection point small and supports direct cable attachment. Rotor position is measured by an integrated multi-turn absolute encoder, so shaft angle is retained across power interruptions and the axis can restart without a homing routine. The drive end uses a plain shaft with a factory-installed shaft seal to help block contaminant entry. The opposite end remains closed because the unit is supplied without a side-B shaft extension. Motor size code 093 and length code C indicate the frame geometry and active stack length for this version.