Product Description:

The MDD093C-L-030-N2L-130GB0 belongs to the MDD Synchronous Motors series manufactured by Bosch Rexroth Indramat. It is an AC servo motor intended for pairing with digital drive controllers in positioning or speed-regulated axes on packaging machines, transfer lines, and general automation. By integrating into closed-loop drive systems, the motor converts commanded current into precise mechanical rotation so that downstream mechanics can follow programmed motion profiles with minimal latency. This operating role makes it suitable for axes that must accelerate, stop, and reverse with consistent response.

This model has a centering diameter of 130 mm, providing a large pilot surface that keeps the stator concentric with gearbox flanges or mounting fixtures. All power and feedback leads exit on Side B, which keeps cable routing on one face of the motor and can reduce interference with adjacent machine members. The frame uses a surface-cooled housing, so heat is transferred directly to the machine wall or an external heat sink instead of relying on internal airflow. Its construction follows a C motor length code, which uses a longer active stack than the A or B variants and supports higher continuous torque at the same thermal limit. Under rated excitation, the rotor reaches 3000 rpm, a synchronous speed suited for moderate-inertia loads that need fast indexing while staying within common gearbox input limits.

Rotor position is returned through digital servo feedback, enabling the drive to close a high-resolution control loop without external encoders. A positively fitted shaft seal blocks coolant splash and fine dust from migrating along the output journal into the bearing set. The output end is a plain shaft, allowing couplings or pulleys to be pressed on without keyways where low backlash is important. Because the motor ships without a blocking brake, any static holding torque must be supplied by the drive or by an external mechanical lock during power-off conditions.