Product Description:

The MDD093C-L-030-N2L-130GA1 is a three-phase permanent-magnet servo motor produced by Bosch Rexroth Indramat for the MDD Synchronous Motors series. Built for digital drive controllers, it converts commanded current into precise rotary motion for positioning and speed tasks in automated handling modules, tooling axes, and high-cycle packaging stations. When paired with a compatible Indramat drive, it receives real-time current setpoints that translate directly into rotor torque, enabling tight synchronization within multi-axis systems. Its permanent-magnet design also supports responsive control during repeated starts, stops, and direction changes.

Its nominal speed of 3000 rpm can be maintained continuously because the housing is prepared for surface cooling and conducts heat away from the stator laminations. An integrated blocking brake rated at 11 Nm secures vertical or suspended loads whenever the drive is disabled. Accurate mechanical alignment is simplified by a flange pilot diameter of 130 mm, while rotor position is reported through digital servo feedback for high-resolution closed-loop control. The motor is built for surface cooling, which supports higher continuous current than a naturally cooled version. The feedback system allows the drive to correct position and speed deviations quickly during changing load conditions.

Cabling exits on Side A, keeping plugs accessible when the motor is mounted deep inside machinery. The stator stack follows the C length code, which places the motor in the medium housing length of this frame series. The motor uses frame size 093, which corresponds to the mechanical envelope used for this model. A plain shaft with a shaft seal transmits torque while helping block coolant or lubricant ingress. The single-ended shaft arrangement leaves no extension on side B, which helps conserve installation space in compact machine assemblies.