Product Description:

The MDD093C-L-030-N2L-130GA0 synchronous servo motor is produced by Bosch Rexroth Indramat within the MDD Synchronous Motors series. As a motor for digital drive controllers, it delivers commanded torque to rotary tooling, indexing tables, and pick-and-place heads in automated production lines. The model integrates permanent-magnet excitation and stator windings sized for medium-frame machinery, letting motion controllers perform closed-loop speed and position tasks without mechanical transmission slack. Its design allows direct coupling to gearboxes or load shafts, simplifying installation in packaging, printing, and material-handling equipment that demands repeatable, coordinated motion.

Mechanical alignment is handled by a centering diameter of 130 mm, giving the housing a precise pilot fit on the machine frame. Power and encoder conductors exit on side A, and a single connector groups the terminations to reduce wiring complexity. During operation, the rotor can reach a nominal speed of 3000 rpm, a value suited to common 50/60 Hz inverter outputs and standard gearbox ratios. Speed feedback is supplied through digital servo feedback (DSF), so the controller receives high-resolution position data for each electrical cycle. The motor follows standard dynamic balancing practices and carries the C length code, which increases active stack height for higher continuous torque.

Thermal management relies on a housing prepared for surface cooling, allowing external air movers or conductive panels to remove heat without internal fans. When the axis must hold position after power is removed, external brakes are required because the motor is delivered without a blocking brake. The output shaft uses a plain shaft geometry to fit clamp or keyless couplings, and ingress protection at the bearing face is improved with a shaft seal. This arrangement supports direct coupling and helps protect the bearing area during regular industrial operation.