Product Description:

The MDD093C-L-030-N2L-110PR1 is a synchronous servo motor produced by Bosch Rexroth Indramat for the MDD Synchronous Motors series. Classified as a motor for digital drive controllers, it converts inverter output into controlled torque and speed for automated tooling, pick-and-place stations, and material transport axes. Its permanent-magnet rotor and integrated feedback allow the drive system to correct position errors quickly during acceleration, deceleration, and steady-state motion. This makes the motor suitable for applications that require repeatable positioning and stable velocity control throughout continuous production cycles.

The motor reaches a nominal speed of 3000 rpm under rated operating conditions. A blocking brake is fitted and provides 11 Nm of static holding torque so that vertical axes or parked loads can remain in place when power is removed. Mechanical alignment is assisted by a centering pilot of 110 mm, and the output shaft uses a keyway for secure torque transfer to pulleys, couplings, or gearboxes. The shaft is supplied with a shaft seal to help protect the bearing area from dust and oil splash. Power and feedback conductors exit on the right side through a plug-in connector housing, which helps keep cable routing orderly in compact machine layouts.

Thermal performance is based on a surface-cooled housing, so heat is transferred through the outer frame into the surrounding structure without separate fan units or liquid jackets. Position and speed are reported through digital servo feedback (DSF), allowing the controller to maintain accurate commutation and responsive closed-loop regulation. The stator uses the C length code within the 093 frame size, giving the motor an intermediate active length that balances output capability and overall mass. Standard dynamic balancing helps reduce vibration at higher speeds, and the single-ended shaft arrangement leaves out a side-B shaft extension to save installation space in inline drive systems.