Product Description:

The MDD093C-L-030-N2L-110PB2 is a servo motor manufactured by Bosch Rexroth Indramat and assigned to the MDD Synchronous Motors series. As a motor for digital drive controllers, it converts commanded current into torque so automated machinery can accelerate, position, and regulate rotary loads with precise feedback. The design uses the 093 frame with C length to provide moderate continuous power while remaining compact enough for cabinet-mounted systems and gantry-based equipment used in general industrial automation.

Its nominal speed is 3000 rpm, which indicates the shaft can rotate at three thousand revolutions per minute under rated operating conditions. A blocking brake rated at 22 Nm is installed, and this normally closed brake holds the axis when power is removed or during stopping events. Position information is transmitted through digital servo feedback, allowing the drive to detect small positional errors and correct them in real time. A centering diameter of 110 mm aligns the motor housing with the machine mounting face for accurate concentricity. Torque is delivered through a keyway shaft, which helps prevent slip between the shaft and the driven component.

The housing is configured for surface cooling, so heat is removed through the motor surface by external airflow or a connected mounting structure rather than an internal fan. The electrical and encoder leads exit on side B, which can simplify cable routing where installation space is limited. Power and signal connections terminate through a rear connector, allowing the motor to be connected without hard-wired lead preparation. Dynamic balance is performed to the standard grade, which helps limit vibration transmitted to adjacent machine components. The motor also includes a shaft seal to help protect the bearing area from coolant splash, and it uses a single-ended shaft layout for typical motion-control assemblies.