Product Description:

The MDD093C-L-030-N2L-110GA2 is a synchronous servo motor produced by Bosch Rexroth Indramat for the MDD Synchronous Motors series. It is built for use with digital drive controllers where precise torque and position control are required in automated machinery. When installed, the motor converts controlled electrical input into accurately regulated mechanical rotation for indexing axes, feeder systems, or packaging stations. Its closed-loop application makes it suitable for motion tasks that require repeatable starts, stops, and position changes during continuous machine operation.

The unit reaches a nominal speed of 3000 rpm, giving the drive a fixed operating speed for matched motion control. Mounting is centered with a 110 mm pilot diameter, which simplifies alignment to machine flanges or gearboxes. A blocking brake delivers 22 Nm of holding torque, allowing the axis to remain stationary during power-off periods. Position data is returned through digital servo feedback, so the controller can regulate motion without a separate external encoder. Thermal dissipation relies on a housing prepared for surface cooling, and contact with a cooling plate or guided airflow helps remove heat during continuous duty.

Cabling exits on side A, allowing power and feedback leads to run in the same direction as nearby drive components. A keyed circular connector carries the motor phases and brake supply, which keeps the electrical interface compact and easy to route. Contaminant ingress is reduced by the installed shaft seal, making the plain output shaft suitable for lightly wet or dusty areas. The motor uses frame size 093, and the C length adds stack height for higher continuous torque within this platform. Standard dynamic balancing and the absence of a side-B shaft end help the motor fit couplings, belt pulleys, and low-backlash gearheads.