Product Description:

The Bosch Rexroth Indramat MDD093B-N-040-N2L-130GA1 is part of the MDD Synchronous Motors series and is supplied as a motor for digital drive controllers in factory automation lines. As a permanent-magnet synchronous unit, it converts regulated drive current into rotational motion that can be coordinated with servo amplifiers. This makes the motor suitable for positioning axes, packaging stations, and printing machinery where repeatable speed and position control are required. Its design is intended for closed-loop servo applications that demand stable motion under changing load conditions.

It delivers a continuous torque of 14.5 Nm at standstill, so the axis can hold static loads without overheating during normal operation. A blocking brake rated at 11 Nm helps secure vertical or suspended shafts when power is removed. The rotor can reach a nominal speed of 4000 rpm, allowing fast cycle times when paired with a matching drive. Precise alignment to a fixture is simplified by a centering pilot of 130 mm in diameter and by standard balancing that helps reduce residual vibration at that speed. Feedback to the controller is generated by digital servo feedback (DSF), which supports commutation and position control without an external encoder. Electrical terminations use a sealed connector, and the housing is the standard version with an integral shaft seal.

Size code 093 sets the stator cross-section, and length code B gives the motor its active stack depth while balancing thermal capacity with the installed footprint. Cabling exits on Side A, so power and feedback conductors can follow a single routing path inside the cabinet. The output spindle is a plain shaft in a standard single-ended configuration, leaving no extension on side B. This layout simplifies coupler selection and keeps dynamic mass low. The motor can therefore be integrated into machine assemblies that need compact servo hardware and straightforward cable routing.