Product Description:

The MDD093B-N-030-N2M-110GR2 belongs to the MDD Synchronous Motors series from Bosch Rexroth Indramat. It is designed for use with digital drive controllers and converts commanded current into controlled rotary motion for industrial axes. In distributed automation cells, the motor serves as the rotary actuator for positioning and speed-controlled tasks, allowing the connected drive to regulate motion directly at the machine axis. This arrangement is suitable for systems that require repeatable servo response without adding unnecessary mechanical complexity between the motor and the driven load.

During static loading, the motor can sustain a continuous torque of 14.5 Nm, which supports stable holding force at standstill. At its rated operating point, the rotor reaches 3000 rpm, which suits mid-range feed screws and belt-driven transmissions. Position feedback is provided by an integrated multiturn absolute encoder, and signal exchange uses digital servo feedback (DSF) so the controller can track shaft position through repeated revolutions and after power cycles. A built-in blocking brake supplies 22 Nm of holding torque, which helps secure vertical loads when drive power is removed. The housing uses a standard unventilated design, and cabling is connected through a sealed interface that keeps the electrical connections enclosed.

Mechanical alignment uses a centering bore of 110 mm, and all service leads exit on the right side to support consistent cable routing. The overall body length is coded as B, matching the 093 frame size used for this motor platform. The output uses a plain shaft with an integral shaft seal to help limit oil ingress during operation. There is no side-B shaft end, which reduces overhung mass at the driven element. The standard housing geometry and connector-based wiring support integration with compatible drive modules and machine layouts.