Product Description:

The MDD093B-N-030-N2M-110GA0 is a synchronous servo motor produced by Bosch Rexroth Indramat for the MDD Synchronous Motors series. Classified as a motor for digital drive controllers, it converts regulated three-phase inverter power into precise rotary motion for industrial automation cells, pick-and-place axes, and material-handling stations. That operating role makes it suitable for machinery that depends on repeatable acceleration, stable speed control, and accurate stopping over frequent duty cycles. A standard housing encloses the stator stack, and internal balancing helps keep vibration within acceptable limits when the motor is mounted through its centering pilot.

The motor reaches a nominal speed of 3000 rpm, which is its rated rotor speed for continuous operation. At standstill it delivers 14.5 Nm of continuous torque, allowing the drive to hold a load with servo current while the shaft remains stopped. Closed-loop control uses digital servo feedback (DSF), and position is captured by an integrated multiturn absolute encoder, so the drive can recover the actual shaft angle after power loss. This arrangement lets the controller monitor rotor position during both speed regulation and positioning tasks. A shaft seal is fitted at the output end to help block oil and dust from entering the bearing cavity. The motor also has a plain shaft, a size 093 frame, length code B, and connector-style power and feedback terminations.

A centering pilot of 110 mm aligns the flange to gearboxes or machine plates with minimal runout. All power, feedback, and brake leads exit on Side A through a single connector, so cable routing stays on one face of the machine and simplifies installation in tight spaces. Because the unit is supplied without a blocking brake, any vertical axis must rely on an external clamp or drive-applied holding torque during power-off states.