Product Description:

The MDD093B-N-030-N2L-130PB0 is a synchronous servo motor manufactured by Bosch Rexroth Indramat within the MDD Synchronous Motors series. As a motor for digital drive controllers, it receives regulated three-phase power from a compatible inverter and converts commanded current into precise rotary torque. It is intended for industrial axes that require repeatable speed control, consistent positioning, and stable torque response during changing loads. Typical uses include conveyors, pick-and-place gantries, and forming presses where closed-loop motion must remain accurate throughout repeated operating cycles. This arrangement lets the connected drive regulate acceleration, deceleration, and settling behavior with a stable motion response.

The motor sustains a continuous standstill torque of 14.5 Nm, allowing closed-loop drives to hold static loads without thermal overload. During motion, the rated mechanical output corresponds to a nominal speed of 3000 rpm, so the controller can command rapid indexing or steady production movement at that velocity. A centering diameter of 130 mm locates the flange accurately on the machine frame and helps keep the rotor aligned with the driven equipment. All power and feedback conductors terminate through a connector, and position information is supplied by integrated digital servo feedback (DSF) for precise commutation and stable velocity regulation.

Cabling exits on side B, which helps route wiring away from gearboxes or coolant manifolds near the drive end. The rotor uses a standard balancing class to help reduce residual vibration during high-cycle operation. The output is configured with a shaft seal, which helps retain grease and limit dust entry at the shaft opening. The frame size is 093, matching couplings, gear stages, and mounting patterns intended for that motor size. The motor does not include an internal holding brake, so static load retention must be provided by the drive or by external mechanical means when power is removed.