Product Description:

The MDD093B-N-030-N2L-130GB0 is a servo motor produced by Bosch Rexroth Indramat within the MDD Synchronous Motors series. As a motor for digital drive controllers, it converts electrical energy into controlled mechanical rotation for positioning and velocity tasks in automated machinery. The unit fits installations that require compact layouts because the B-length frame pairs a standard housing with an integrated feedback connector, allowing straightforward integration into motion axes coordinated by Indramat drive amplifiers.

Its continuous standstill torque is rated at 14.5 Nm, meaning the rotor can hold static loads at that value indefinitely without thermal overload when the windings are energized. A nominal speed of 3000 rpm establishes the reference velocity where the torque-speed curve intersects the continuous operating zone for typical servo duties. The centering diameter of 130 mm aligns the motor flange precisely on mating machine surfaces to minimize radial runout. Because the unit is supplied without a blocking brake, external mechanical restraints must secure vertical or overhung loads during power-off states. Position and velocity data are returned through digital servo feedback, allowing the controller to close high-resolution loops without separate encoders.

Electrical power and feedback cables exit on side B, so panel layouts can be planned with fixed conduit lines toward the rear of the machine. The single plug-in connector simplifies removal for service and matches the plain shaft configuration intended for rigid clamp couplings. Frame size 093 supplies a rotor inertia compatible with mid-range drives, while a factory-installed shaft seal protects the front bearing against coolant splash and airborne dust. Standard dynamic balancing, a plain shaft end on the drive side only, and a standard housing finish complete the mechanical interface without adding mass or length beyond the quoted B-code envelope.