Product Description:

The MDD093B-N-020-N2L-130GL0 is a synchronous servo motor produced by Bosch Rexroth Indramat within the MDD Synchronous Motors series. Intended for pairing with digital drive controllers, this motor converts electrical commands into precise rotary motion used to index tooling stations, move conveyor sections, or regulate axes in automated packaging lines. Its design supports closed-loop control, allowing the drive to monitor rotor position in real time and supply the exact torque required by each machine cycle.

The motor delivers a continuous standstill torque of 14.5 Nm, enough to hold vertical loads when the shaft is energized but stationary. Under rated excitation, the rotor reaches a nominal speed of 2000 rpm, suitable for equipment that needs moderate, stable rotation. A centering diameter of 130 mm helps the stator seat squarely on mounting faces to control vibration. Position data returns through digital servo feedback, letting the drive correct current in short intervals for tight speed regulation. Power and signal leads exit on the left side, simplifying wiring when the motor sits on right-hand machine frames. Standard balancing, a size-093 frame, and the normal housing finish complete the basic mechanical package.

The design also addresses sealing, coupling, and safety. The shaft is shipped without a blocking brake, so stopping or holding must be provided by the drive or external clamps. The motor uses a shaft seal that keeps lubricant in and contaminants out during washdown or dusty service. A single plug-type connector carries power, feedback, and ground in one housing to reduce assembly time. Torque is transmitted through a plain shaft, so couplings rely on shrink-fit or clamping force because no keyway is present. Motor length code B keeps the depth compact, and the shaft end is provided only on side A to save axial space.