Product Description:

The MDD093A-N-060-N2M-110GA0 synchronous servo motor is produced by Bosch Rexroth Indramat within the MDD Synchronous Motors series. Designed for digital drive controllers, it translates commanded current loops into controlled torque and speed for industrial pick-and-place arms, textile winders, and indexing conveyors. The 093 frame combined with length code A keeps the overall package short, while the standard housing and balancing allow installation with minimal vibration transfer. This compact layout suits machine axes where motor length affects carriage overhang and moving mass. A standard shaft end on the drive side eliminates the need for side-B couplings and simplifies alignment during installation.

At a nominal speed of 6000 rpm, the rotor can follow rapid velocity setpoints needed in high-cycle processes. A continuous standstill torque of 9.2 Nm allows the axis to hold static loads without drift while energized. The motor is centered by a 110 mm pilot diameter that helps preserve concentricity between the flange and attached mechanics. Power and feedback plugs exit on Side A, preventing cable loops across moving structures, and a single keyed connector interface supports straightforward connection to the mating harness. This arrangement also helps keep the cable run close to the machine frame.

Position and velocity signals are returned through digital servo feedback, and the integrated multiturn absolute encoder keeps track of shaft angle over more than one revolution, so the axis can restart without a homing routine. A plain shaft transmits torque through friction-fit couplings and is guarded by a shaft seal that blocks coolant spray and fine dust from entering the front bearing. The motor is supplied without a blocking brake, so any holding function must be provided by the drive or an external clamp. The motor uses standard balancing and a standard housing, and it has no side-B shaft.