MDD093A-N-040-N2M-110GL2 Bosch Rexroth Indramat
Wake Industrial LLC is not an authorized distributor of this product.
- Straightforward Pricing: No Rush Fees, No Credit Card Fees
The Bosch Rexroth Indramat MDD093A-N-040-N2M-110GL2 is a motor for digital drive controllers in the MDD Synchronous Motors series. It features a continuous torque at standstill of 9.2 Nm, a nominal speed of 4000 min⁻¹, and has an integrated multiturn absolute encoder with digital servo feedback. The motor includes a blocking brake with a holding brake torque of 22 Nm and a plain shaft with a shaft seal.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The MDD093A-N-040-N2M-110GL2 is a synchronous servo motor produced by Bosch Rexroth Indramat within the MDD Synchronous Motors series. It is intended for use with digital drive controllers and supplies regulated torque and speed to axes in automated machinery. In closed-loop systems, the motor converts drive commands into controlled rotary motion for feed axes, transfer units, and similar machine functions. A standard housing and factory balancing support direct integration into general-purpose mechanical frames. The motor is suited for applications that require consistent positioning response and stable speed control during repetitive cycles.
This model sustains a continuous standstill torque of 9.2 Nm, giving it the capacity to hold moderate loads without overheating. Under command from the drive, the rotor reaches a nominal speed of 4000 rpm, a range suited for fast positioning tasks. A blocking brake delivers 22 Nm of static torque so vertical or suspended axes remain fixed when power is removed. Feedback to the controller is provided by digital servo feedback (DSF), which supports tight velocity and position loops. Mechanical output is transmitted through a plain shaft, and the smooth shaft end helps simplify coupling alignment. Power and signal connections use the standard connector arrangement, which keeps wiring compact along the machine frame. The motor has length code A and size 093, which set the overall envelope for installation.
Installation reference points include a centering diameter of 110 mm, which locates the flange precisely on companion mounts. Cabling exits on the left, which helps when routing lines inside tight enclosures. An integrated multiturn absolute encoder reports position over multiple revolutions, so the axis can retain position information after power loss. Contamination ingress is limited because the shaft is supplied with a shaft seal. The shaft end is single-sided to fit inline transmission layouts. This arrangement helps maintain clean operation around the front bearing area.
Frequently Asked Questions about MDD093A-N-040-N2M-110GL2:
Q: What type of encoder is used in the MDD093A-N-040-N2M-110GL2 motor?
A: The MDD093A-N-040-N2M-110GL2 is equipped with an integrated multiturn absolute encoder for accurate position tracking.
Q: Does the MDD093A-N-040-N2M-110GL2 motor feature a holding brake, and what is its torque?
A: This servo motor includes a holding brake with a torque of 22 Nm.
Q: What is the continuous torque at standstill for the MDD093A-N-040-N2M-110GL2 motor?
A: The MDD093A-N-040-N2M-110GL2 offers a continuous torque at standstill of 9.2 Nm.
Q: What is the nominal speed of the MDD093A-N-040-N2M-110GL2 servo motor?
A: Its nominal speed is rated at 4000 min⁻¹, supporting high-speed applications.
Q: What type of shaft and sealing does the MDD093A-N-040-N2M-110GL2 feature?
A: This model is manufactured with a standard plain shaft and includes a shaft seal for protection against contaminants.
