Product Description:

The MDD093A-N-030-N2M-130PL2 is a synchronous servo motor produced by Bosch Rexroth Indramat within the MDD Synchronous Motors series. As a motor for digital drive controllers, it supplies rotational power and position feedback for automated axes that rely on precise closed-loop regulation. This frame size 093 unit integrates directly with Indramat drives to support mid-range torque requirements in material handling, packaging, and general machinery. It is intended for repeated positioning and speed-controlled motion where stable servo response is needed across changing loads.

At standstill, the motor can deliver 9.2 Nm of continuous torque. Its operating speed is 3000 rpm, which suits general-purpose servo applications that run at a fixed base speed. A blocking brake resists 22 Nm when power is removed, allowing vertical axes to hold position. Position and velocity data are returned through digital servo feedback (DSF), so the controller can close the loop without external encoders. Mechanical alignment is aided by a 130 mm centering diameter, which helps the motor seat accurately on compatible mounting surfaces. The rotor uses standard balancing to reduce vibration during operation. The motor has the short A length, power and feedback pass through a single connector, and the shaft does not have a side B extension.

The wiring exits on the left side, which can simplify cable routing in tight enclosures and reduce congestion around nearby components. An integrated multi-turn absolute encoder tracks revolutions across power cycles, so the axis can retain position information after shutdown and startup. A shaft seal helps keep contaminants away from the front bearing, and torque is transmitted through a keyway machined into the shaft. Natural convection is adequate for typical machine-room operation, and the housing is the standard uncooled version. The mounting pattern matches other motors in the same frame.