Product Description:

The MDD093A-N-030-N2L-130GL0 is a synchronous motor from the MDD Synchronous Motors series that Bosch Rexroth Indramat builds for use with digital drive controllers in automated machinery. By converting electrical power from an inverter into precisely regulated mechanical motion, the unit provides closed-loop positioning and speed control for packaging lines, material-handling axes, and similar tasks. Its design follows the series convention for frame size 093 with motor length code A, giving a compact profile that matches mid-range inertia requirements while maintaining compatibility with standardized mounting interfaces.

At standstill, the motor can deliver 9.2 Nm of continuous torque, which is the maximum steady load the stator windings can support without thermal overload. When supplied with rated current, it reaches a nominal speed of 3000 rpm, allowing direct coupling to belt drives or low-ratio gearboxes that need high cycle rates. The centering flange measures 130 mm in diameter, providing accurate alignment on machine frames and helping minimize vibration. Rotor position is reported through Digital servo feedback (DSF), so the connected controller receives high-resolution commutation and diagnostic data during each revolution. Power and feedback conductors are joined through a rugged connector, which simplifies cable attachment and helps maintain the housing seal.

The motor uses a plain shaft finished to ISO tolerances, and the output end is supplied without a keyway. For applications that hold position with drive torque alone, the motor is shipped without a blocking brake, reducing mass and inertia. Service cabling exits on the left side, an arrangement that helps compact layouts where multiple axes sit side by side. A configuration with a shaft seal protects the bearings against coolant spray, and the standard housing encloses the stator laminations for reliable operation in industrial environments.