Product Description:

The MDD093A-N-030-N2L-110PR1 is a synchronous servo motor built by Bosch Rexroth Indramat in the MDD Synchronous Motors series. As a motor for digital drive controllers, it converts commanded electrical input into precisely regulated mechanical rotation for positioning tasks across assembly lines, packaging machines, and material-handling axes. Its design supports rapid-response torque in automated systems that depend on real-time feedback and tight motion loops.

At standstill, the motor can deliver 9.2 Nm of continuous torque, enabling it to sustain load forces without overheating when the shaft is held by the integrated blocking brake. The rated operating point is a nominal speed of 3000 rpm, so the rotor reaches that velocity when the drive applies rated voltage and frequency. For short-term holding on vertical axes, the mechanical brake supplies 11 Nm of holding torque, preventing back-drive when power is removed. Accurate velocity and position control is supported by a flange with a 110 mm centering diameter that seats the motor concentrically, while the encoder returns digital servo feedback (DSF) to the drive. Power and signal conductors share a single industrial connector, and size code 093 with length code A indicates the motor format used for this output.

Installation details include a Right-side connection orientation that keeps the cable exit clear of adjacent machinery when the motor is mounted on its flange. Rotor mass distribution is maintained by standard balancing, allowing coupling to gearboxes or belt pulleys without additional correction. To protect internal bearings from contaminant ingress, the front flange is equipped with a shaft seal, and power is transmitted through a keyway shaft interface that helps prevent slip under cyclic loads. This layout suits direct connection to common transmission elements used in packaging, indexing, and material-handling equipment.