Product Description:

The MDD093A-N-030-N2L-110GB1 is a synchronous AC servo motor produced by Bosch Rexroth Indramat for the MDD Synchronous Motors series. Designed for use with digital drive controllers, it delivers repeatable torque and speed for axes that depend on closed-loop regulation in packaging lines, handling modules, and general automation equipment. This operating method allows the connected drive to monitor motion continuously and correct load-related deviations during acceleration, deceleration, and steady-speed operation.

A continuous standstill torque of 9.2 Nm lets the rotor hold static loads without overheating, while the nominal operating speed of 3000 rpm supports rapid positioning cycles when the drive commands full speed. An integrated blocking brake provides 11 Nm of mechanical holding force, helping the axis remain secure after power is removed. All cabling exits on side B, which can simplify routing where motors are installed in mirrored pairs or where cabinet clearance is limited. Feedback to the drive amplifier is provided through Digital servo feedback (DSF), so the controller receives position information for precise velocity and torque control. A multi-pin connector carries both power and signal conductors, and length code A indicates the shortest housing in the 093 frame size.

A centering shoulder diameter of 110 mm helps align the motor accurately in machine frames and mounting surfaces. The output uses a plain shaft, allowing couplings to be clamped directly without a keyway. Factory-applied standard balancing helps keep residual vibration low across the speed range, which supports smooth rotation and reduces stress on connected components. Contaminant ingress at the coupling end is limited by a with a shaft seal design, and the standard housing with a single-ended shaft keeps the non-drive end compact.