Product Description:

The MDD093A-N-030-N2L-110GA1 synchronous servo motor is manufactured by Bosch Rexroth Indramat as part of the MDD Synchronous Motors series. Intended for use with digital drive controllers, it transforms commanded current into tightly regulated rotary motion for axes in packaging, handling, and light machining equipment. The motor integrates a sealed housing and digital feedback so the controller receives continuous position data while internal components remain protected from dust and coolant. Standard rotor balancing helps reduce vibration, and the shaft end supports connection to timing belts, gearboxes, or direct-drive loads.

At the mounting interface, the centering collar on the flange measures 110 mm, providing accurate alignment to connected machinery. Thermally rated windings allow the unit to deliver 9.2 Nm of continuous torque at standstill for holding or slow-feed duties. Under nominal electrical excitation, the rotor reaches 3000 rpm, matching the speed range commonly used in 093-frame synchronous designs. During an emergency stop or power loss, the integrated blocking brake supplies 11 Nm of static torque to help prevent unwanted shaft rotation. Rotor position is transmitted through digital servo feedback (DSF), allowing the drive electronics to perform high-resolution commutation, velocity regulation, and fault detection.

Cable exits are oriented on Side A, keeping power, brake, and feedback leads on the drive side of the machine for orderly routing inside enclosures. A keyed circular connector combines the main phases and brake supply, which helps simplify installation. The motor uses length code A, the most compact version in the 093 size, which helps reduce rotor inertia for faster acceleration cycles. It has a plain shaft with a shaft seal, allowing direct clamping of couplings while helping block lubricant ingress. The standard housing and centering diameter support accurate mounting on compatible machine interfaces.