Product Description:

The MDD093A-N-020-N2M-130PL1 is a synchronous servo motor manufactured by Bosch Rexroth Indramat and included in the MDD Synchronous Motors series. Classified as a motor for digital drive controllers, it delivers position-controlled rotary power for industrial handling units, packaging machines, and similar automation tasks where closed-loop speed and torque regulation are required. Its design suits axes that must start, stop, and hold position repeatedly without losing feedback accuracy. That combination makes it appropriate for automated motion systems that depend on stable response across changing load conditions.

This model sustains a continuous standstill torque of 9.2 Nm, allowing it to hold loads without overheating when the shaft is locked. During motion, the rotor can reach a nominal speed of 2000 rpm, a value matched to drives that issue 400 Hz electrical excitation. A blocking brake is integrated, and its holding force is rated at 11 Nm, so the shaft can remain secured during power-off conditions or emergency stops. Mounting alignment is aided by a centering pilot diameter of 130 mm. Feedback precision is provided by an integrated multi-turn absolute encoder, which supplies multi-revolution position data to the controller.

Control electronics receive rotor position through Digital servo feedback (DSF), enabling tight speed loops without external sensors. The single shaft end is machined with a keyway, which simplifies torque transfer to pulleys or couplings, and the shaft area is protected by a compliant seal to limit ingress. The rotor uses standard balancing to reduce vibration in high-cycle operation. Wiring passes through a sealed connector interface, and both power and signal plugs are oriented on the housing's left side for consistent cable routing. The motor keeps the standard size 093 and length code A format, while the absence of a secondary shaft end helps preserve a compact overall envelope.