Product Description:

The MDD093A-N-020-N2L-130GL0 is a synchronous motor manufactured by Bosch Rexroth Indramat within the MDD Synchronous Motors series. Classified for use with digital drive controllers, it serves as the rotary actuator in automated presses, gantry axes, and packaging stations. A permanent-magnet rotor and integrated feedback allow the connected drive to regulate speed and position with high accuracy. This arrangement supports closed-loop motion in machines that need repeatable starts, stops, and speed changes. Its housing format follows the standard layout used for this motor family, so it fits machine layouts built around the same frame.

The motor has a nominal speed of 2000 rpm, which is the synchronous rate used during continuous duty. At standstill, it can deliver a continuous torque of 9.2 Nm, which helps the shaft resist process load until motion resumes. Accurate alignment is achieved with a 130 mm pilot diameter that fits the mating machine recess. Rotor position is reported through digital servo feedback, so the controller can correct motion during each sampling cycle. Cables exit on the left side, which helps keep the harness away from components mounted on the opposite side of the motor.

Residual vibration is limited by standard balancing, which helps the motor run smoothly through its speed range. Power enters through a shielded connector, and the housing uses a standard cast construction. The output uses a plain shaft and is fitted with a shaft seal for oil containment. Because there is no side-B shaft end, mechanical coupling is arranged only on the drive side. The motor is supplied without a blocking brake, so any holding torque required at power-off must come from the drive or an external mechanism. The size 093 and length A configuration give the unit a compact overall length for its frame.