MDD090C-N-040-N2L-130GB1 Bosch Rexroth Indramat
Wake Industrial LLC is not an authorized distributor of this product.
- Straightforward Pricing: No Rush Fees, No Credit Card Fees
The Bosch Rexroth Indramat MDD090C-N-040-N2L-130GB1 is a digital drive controller motor from the MDD Synchronous Motors series. It features a continuous torque at standstill of 10.4 Nm, nominal speed of 4000 rpm, and comes with a holding brake and shaft seal. The motor is equipped with digital servo feedback and has a centering diameter of 130 mm.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The MDD090C-N-040-N2L-130GB1 is a three-phase synchronous servo motor engineered by Bosch Rexroth Indramat for the MDD Synchronous Motors series. Designed to operate with digital drive controllers in factory automation, it converts regulated AC input into controlled torque and speed, allowing actuators, gantries, and transfer lines to position payloads repeatably and maintain commanded motion profiles. Its synchronous design supports accurate response to changing load conditions, which is useful in transfer systems that require steady positioning and repeatable cycle times. This arrangement lets the motor work with servo systems that depend on stable torque production at low speed and rapid correction during indexing moves.
Mechanical alignment is aided by the 130 mm centering diameter that fits tightly into matching recesses on mounting plates. At standstill, the rotor can supply a continuous torque of 10.4 Nm, which is the amount of torque it can support continuously without overheating. When motion starts, the motor can reach a nominal speed of 4000 rpm, balancing rapid acceleration with practical bearing life. Cables leave the stator housing on side B, keeping service loops clear of moving equipment, and the integrated round connector simplifies electrical connection at installation.
In vertical axes, the blocking brake generates 6.5 Nm of static holding torque, preventing drift when power is off or the drive is in a safe state. Motion control accuracy is reinforced by digital servo feedback (DSF), which returns instantaneous rotor position to the drive for closed-loop regulation. Frame size code 090 identifies the motor size, and length code C extends the iron stack for additional flux. Rotor and shaft are balanced to Standard grade, which helps reduce vibration when the plain shaft is coupled directly. The housing is standard and includes a shaft seal that helps keep lubricants away from the windings, while the single-ended shaft arrangement leaves side B available for the electrical connection.
Frequently Asked Questions about MDD090C-N-040-N2L-130GB1:
Q: Does the MDD090C-N-040-N2L-130GB1 motor include a holding brake?
A: The MDD090C-N-040-N2L-130GB1 motor is equipped with a holding brake that provides a brake torque of 6.5 Nm.
Q: What kind of feedback does the MDD090C-N-040-N2L-130GB1 motor provide?
A: This motor features digital servo feedback (DSF) for precise position monitoring and control.
Q: What is the continuous standstill torque of the MDD090C-N-040-N2L-130GB1?
A: The MDD090C-N-040-N2L-130GB1 motor offers a continuous torque at standstill of 10.4 Nm.
Q: Where is the connection located on the MDD090C-N-040-N2L-130GB1 motor and what type does it use?
A: The electrical connection for this motor is situated at Side B and uses a connector type interface.
Q: What is the nominal speed rating of the MDD090C-N-040-N2L-130GB1 motor?
A: This motor operates at a nominal speed of 4000 min⁻¹, supporting rapid performance cycles.
