Product Description:

The MDD090C-N-030-N2M-130PR0 is a synchronous servo motor produced by Bosch Rexroth Indramat and supplied within the MDD Synchronous Motors series. Designed for use with digital drive controllers, the unit converts commanded current into rotary motion for positioning tasks on automated axes, pick-and-place modules, or packaging machinery where fast response and repeatable accuracy are required. Its synchronous construction lets the connected drive regulate torque and position with quick response during repeated motion cycles. This makes the motor suitable for coordinated axes that need smooth acceleration and repeatable stopping behavior.

A centering shoulder of 130 mm simplifies concentric alignment against the machine flange and helps support stable running. The rotor can deliver a continuous standstill torque of 10.4 Nm, providing stable holding force for stationary loads without overheating the windings. During operation, the shaft reaches a nominal velocity of 3000 rpm, which supports short cycle times on automated equipment. Position data are provided by an integrated multi-turn absolute encoder, while commutation and speed loops rely on digital servo feedback to maintain precise electrical angle and stable torque control under changing load conditions.

Power and feedback leads exit on the right side, so cable runs can stay compact when several axes are installed close together. The motor uses a shaft with a keyway to transmit torque through standard couplings, and the shaft seal helps block dust or coolant from reaching internal parts. Because the motor is supplied without a blocking brake, external holding force is required if the load must remain fixed after power is removed. This arrangement supports compact machine layouts that need clear cable paths and protected shaft exits. The connector-based electrical interface and the C-length frame fit well in modular machine layouts.