MDD090C-N-030-N2M-110PL1 Bosch Rexroth Indramat
Wake Industrial LLC is not an authorized distributor of this product.
- Straightforward Pricing: No Rush Fees, No Credit Card Fees
The Bosch Rexroth Indramat MDD090C-N-030-N2M-110PL1 is part of the MDD Synchronous Motors series. It features a nominal speed of 3000 min⁻¹ and delivers a continuous torque at standstill of 10.4 Nm. This motor includes an integrated multiturn absolute encoder, a blocking brake with 6.5 Nm holding torque, and a keyway shaft with a 110 mm centering diameter.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The MDD090C-N-030-N2M-110PL1 belongs to the MDD Synchronous Motors series produced by Bosch Rexroth Indramat. Classified as a motor for digital drive controllers, it converts commanded current into controlled torque for industrial positioning and speed-regulated motion. An integrated multi-turn absolute encoder works with the drive so rotor angle is available immediately after startup, supporting continuous closed-loop use in assembly lines and material-handling systems. This arrangement lets the controller correct speed and position deviations during repeated starts, stops, and load changes. It is well suited for axes that need immediate position availability after a restart, especially where homing cycles would interrupt normal machine operation.
During continuous stall, the motor delivers 10.4 Nm of torque, so it can hold a steady load without overheating when properly matched to the drive. At a nominal speed of 3000 rpm, the rotor supports operating speeds commonly used in automated machine cycles. A centering diameter of 110 mm helps align the motor on the mounting surface and supports smooth running. Power and encoder conductors connect through a connector, and the feedback channel uses digital servo feedback for precise position data. Standard dynamic balancing helps reduce radial vibration at the bearings, and the housing uses a sealed standard design. The combined power and feedback connection also reduces the need for separate termination points at the motor body.
An internal blocking brake provides 6.5 Nm of holding torque to secure vertical or suspended loads when power is removed. Machine wiring exits on the left side, which suits layouts where cables are routed from that direction and helps keep cable routing orderly in compact spaces. The motor has frame size 090 and length code C, which place it within the corresponding housing and active core length in the series. A keyed shaft transfers torque to the load, and a shaft seal helps keep lubricant and contamination away from internal components. The shaft has no secondary extension on side B, which leaves the non-drive end in the standard single-ended arrangement.
Frequently Asked Questions about MDD090C-N-030-N2M-110PL1:
Q: What type of encoder is included in the MDD090C-N-030-N2M-110PL1 motor?
A: This motor features an integrated multiturn absolute encoder for precise position measurement.
Q: What is the continuous torque at standstill for this motor?
A: The MDD090C-N-030-N2M-110PL1 provides a continuous torque of 10.4 Nm at standstill.
Q: Does the MDD090C-N-030-N2M-110PL1 include a holding brake and what is its torque?
A: A blocking brake with a holding torque of 6.5 Nm is built into this model.
Q: Where is the electrical connection located and what type does it use?
A: The motor's connection is positioned to the left and utilizes a connector for electrical interfacing.
Q: What kind of shaft and sealing does the MDD090C-N-030-N2M-110PL1 offer?
A: This motor uses a shaft with a keyway and includes a shaft seal for added protection.
