Product Description:

The Bosch Rexroth Indramat MDD090C-N-030-N2L-130PL0 is an AC synchronous servo motor in the MDD Synchronous Motors series. Intended for use with digital drive controllers, it supplies closed-loop motion on packaging lines, gantry axes, and material handling cells. The motor receives controlled three-phase power from the drive, converts it into commanded torque, and returns position data so the controller can maintain precise velocity and position profiles during automated cycles. This operating role suits axes that need repeatable starts, stops, and synchronized speed changes during automated production.

At a continuous standstill torque of 10.4 Nm, the rotor can supply sustained force without overheating, which is important for vertical loads or dwell periods. The rated speed is 3000 rpm, setting the velocity limit at nominal voltage and frequency and allowing suitable gearbox selection for target cycle times. A centering diameter of 130 mm provides a locating surface that keeps the stator concentric with adjoining frames and helps minimize radial runout. With the power and feedback plugs oriented to the left side, cabinet layouts can keep all cables on a common side. Rotor position is measured through digital servo feedback, permitting high-resolution interpolated motion and allowing the drive to detect small positional deviations. The feedback channel also supports stable correction of tracking errors during acceleration and deceleration.

Power reaches the windings through a single connector, so installation remains straightforward and no hard-wired joints need to be re-terminated. The output shaft is machined with a keyway, allowing rigid coupling to pulleys or gear hubs. Because the motor ships without a blocking brake, holding torque during power-off must be provided by external clamping devices when required. A fitted shaft seal limits lubricant ingress at the bearing seat and helps protect the bearing area during extended duty. Motor length code C, size 090, and a standard side A shaft end match the form factor commonly used across this series and keep the coupling orientation consistent with common machine layouts.