Product Description:

The MDD090C-N-020-N2L-130GL2 is a synchronous AC servo motor built by Bosch Rexroth Indramat for the MDD Synchronous Motors series. Classified as a motor for digital drive controllers, it supplies programmable torque and speed for automated handling equipment, packaging stations, and multi-axis motion lines. By combining permanent-magnet excitation with internal rotor feedback, the unit converts electrical commands from the drive into precise shaft rotation and supports closed-loop positioning in production environments where repeatable motion and stable response are required. In operation, it is intended for axes that must follow commanded motion profiles with consistent accuracy through repeated cycles.

The motor’s nominal speed is 2000 rpm, allowing moderate-speed processes while retaining high resolution through the integrated digital servo feedback system. At standstill, it can deliver a continuous torque of 10.4 Nm, which indicates the steady load it supports without thermal overload. Mechanical alignment to the driven machine is centered by a 130 mm locating pilot, which helps keep the shaft and mating parts properly aligned. Power and feedback conductors exit on the left side through a sealed connector housing, and the motor is built without a side B shaft extension so the rear face remains clear for surrounding machine hardware and nearby axis components.

To secure the load when power is removed, the motor incorporates a blocking brake that holds up to 11.0 Nm. The rotor is matched with standard balancing, which helps the motor run smoothly beside adjacent axes during normal operation. The motor uses frame size 090 with a C length code, keeping the profile compact while maintaining the thermal capacity associated with this housing length. The output uses a plain shaft rather than a keyed shaft, which suits coupling methods that clamp directly to the shaft surface.