MDD071C-N-060-N2T-095GB1 Bosch Rexroth Indramat
Wake Industrial LLC is not an authorized distributor of this product.
- Straightforward Pricing: No Rush Fees, No Credit Card Fees
The Bosch Rexroth Indramat MDD071C-N-060-N2T-095GB1 is a motor for digital drive controllers from the MDD Synchronous Motors series. It features a nominal speed of 6000 rpm and a continuous torque at standstill of 6.6 Nm. This motor includes an integrated multiturn absolute encoder and a holding brake with 3.0 Nm of torque.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The MDD071C-N-060-N2T-095GB1 is a three-phase synchronous servo motor produced by Bosch Rexroth Indramat within the MDD Synchronous Motors series. Designed for digital drive controllers, it serves as the electromechanical actuator in automated handling units, packaging systems, and gantry axes where high speed and cyclic repeatability are required. The unit uses permanent-magnet excitation and closed-loop feedback to deliver commanded motion profiles with accurate response. Its standard housing and plain shaft simplify integration into gearboxes or belt transmissions, while the internal encoder signals allow the controller to close precise position and velocity loops.
At a nominal speed of 6000 rpm, the rotor can reach high linear surface velocities, making the motor suitable for rapid indexing tasks. Its continuous torque at standstill is 6.6 Nm, so the drive can maintain static loads without exceeding thermal limits when the axis is clamped in position. For power-off safety, the integrated blocking brake supplies 3.0 Nm of holding torque, securing vertical or suspended loads until drive torque is restored. Mechanical mounting aligns on a 95 mm centering diameter, allowing concentric positioning against the machine frame and minimizing radial runout. Motion feedback is provided by an integrated multi-turn absolute encoder, which returns both shaft position and revolution count to the controller immediately after power-up.
Feedback signals are transmitted as digital servo feedback (DSF), a serial protocol that reduces cabling while preserving high-resolution position data. Power, brake, and encoder connectors are oriented toward the rear because the wiring exits on Side B, which simplifies cable routing on machines that place the motor nose toward the workpiece. The drive end uses a plain shaft with a factory-installed shaft seal to limit lubricant migration into the stator. With length code C, the unit balances inertia and thermal mass, giving a favorable torque-to-size ratio for compact multi-axis modules.
Frequently Asked Questions about MDD071C-N-060-N2T-095GB1:
Q: What type of encoder is included in the MDD071C-N-060-N2T-095GB1 motor?
A: This motor features an integrated multiturn absolute encoder for precise position feedback.
Q: What is the continuous standstill torque rating of this motor?
A: The MDD071C-N-060-N2T-095GB1 provides a continuous torque of 6.6 Nm at standstill.
Q: Does this motor have a holding brake and what is its torque?
A: A holding brake with 3.0 Nm of torque is included in this model for secure stops.
Q: What is the nominal speed specification for the MDD071C-N-060-N2T-095GB1?
A: This motor operates at a nominal speed of 6000 min⁻¹.
Q: What type and direction of electrical connection does this motor have?
A: The electrical connection is positioned on Side B and uses a connector interface.
